To set up IPsec for endpoints with Pulse Desktop Client, you configure policies on the Pulse Policy Secure device, and on the security device. IPsec policies allow you to specify the parameters between endpoints and the Junos Enforcer. The EX Series Ethernet Switch Junos Enforcer does not support IPsec enforcement only Source IP enforcement is supported on the EX Series Junos Enforcer. IPsec enforcement is supported only with the SRX Series Services Gateway Junos Enforcer. You configure security policies on the Junos Enforcer. You configure IPsec routing policies and IP address pool policies on the Pulse Policy Secure device. IPsec is supported on the Junos Enforcer beginning in version 10.0. When a user with Pulse Desktop Client signs in to the Pulse Policy Secure device, these configuration details are passed on to the client to establish an IPsec tunnel with the Junos Enforcer. This information is forwarded to The Pulse Policy Secure device by the respective device. For the client to establish an IPsec tunnel, it must retrieve configuration information from the Junos Enforcer. Pulse Desktop Client support IPsec using IKEv1 with XAuth. IP Security (IPsec) is a suite of related protocols for cryptographically securing communications at the IP Packet Layer. If you create resource access policies with the number of resources greater than the maximum number of filter termsĪllowed, the filter is not installed, and 802.1X authentication fails. The below table shows the number of terms allowed per firewall filter for different EX Series switches. The number of terms you can configure per firewall filter will vary, depending on which EX Series switch you are configuring. A filter term is the access/deny detail for a single resource. This could be a MAC address, or it could be a combination of IP address ranges, ports, and protocol. If you have configured the EX Series switch as an Infranet Enforcer, select the switch in the resource access policy.Ī resource is a single entry in the resource field of the resource access policy. Using resource access policies with an EX Series switch you can configure authorization for protected resources. An auth tables consist of a unique identification number, the MAC address of the endpoint that initiated the session, and a list of roles that the user has been assigned.Īuth tables are sent from PPS to the EX Series switch when a user is authenticated on the network.Īlways Provision and Never Provision Auth table mapping policies are supported for the EX Series switch.įor complete configuration information, see Configuring Auth Table Mapping Policies. The EX Series switch receives and maintains auth tables for valid user sessions with PPS. On the EX Series switch, you use the CLI to configure the connection with PPS. This password is a shared secret that administrators of both the switch and PPS can use for connectivity between the two devices.ĥ.Enter the serial number of the EX Series switch. To configure a Juniper EX switch as an Infranet Enforcer in PPS:ġ.Select Endpoint Policy > Infranet Enforcer.Ģ.Click New Infranet Enforcer and select Junos EX in the Platform drop down.ģ.Enter the name of the EX Series switch in the Name box.Ĥ.Enter the password for the EX Series switch. The EX-series switches provide standards-based 802.1X port-level access control. The EX-series switches will permit or deny network access based on policies developed and distributed by PPS, including those policies based on user authentication status, endpoint posture compliance, user/device role and other policies. Configuring EX switch as an Infranet Enforcer
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |